TUBE CUT OFF - Dimple-Free, Minimal Burr
Depend on Vogel for cut off equipment that will help you increase efficiency, while reduce part handling and cost! Our two-blade cutoff technique, originally patented in 1941, cuts tubes, up to 6” OD, with no OD deformation and minimal burr (10% or less of tube’s wall thickness). Best results achieved with mild steel tubing aluminum, half hard or full hard brass & copper.
Each cut off die will handle a wide range of tube sizes, up to the maximum capacity shown. To change the size of tube to be cut, simply change the die inserts that clamp the tube. The insert changeover may be performed with the cut off die in the press, to reduce down time. Die Inserts are sharpenable. Vertical Blades are low-cost, easily sharpenable and replaceable. Our Horizontal Blade design is reversible for a fresh edge without resharpening.
NOTE: Die inserts and blades sold separately.
Watch cut off die video
Ver video en Español