function googleTranslateElementInit() { new google.translate.TranslateElement({pageLanguage: 'en', layout: google.translate.TranslateElement.InlineLayout.SIMPLE}, 'google_translate_element'); }
US Toll Free: 800.272.8946Outside US: 630.562.1400En Español: 630.628.7056
Need help fabricating parts?
Contact Manor Tool
Tools For Tubular Part Fabrication
This is an example of Vogel's custom die capabilities. Similar to a V-Notch die, this die can be custom built for specific applications where the size of the holes are too large to be pierced in an arbor piercing die or where large windows must be pierced in tubing. Please send us prints of your application details so we may quote a tool specific to your needs.
Unit of Measure


Special Side Notching Die

N/A Notches a circular side notch in 4" pipe. Includes clamp-up action and air shedder for easy removal of part. side_notching04.jpg

Special Double Side Notch Die

N/A With double clamp-up action to notch two 1" long 5/8" wide windows in 1" O.D. x 20 Ga. tubing. side_notching05.jpg

Frequently Asked Questions


    V-Notch & Side Notching

    What angles can I produce?
    Our standard design produces a V-Notch that when folded will create a 90° corner. You can custom order tools for different angles, please consult factory to discuss your application.

    Does the tool cut the tube (into two parts, each with a mitered end)?
    No. This tool cuts three walls of the tube, leaving the rear wall intact, for folding to create your finished corner. If you wish to have two separate parts, each with a mitered end, you will need to purchase a Vogel Cut Off Die, and a Vogel Mitre Snug. Thee press strokes in two different tools will be required.

    Does the tool fold the tube after V-Notching?
    No, we do not provide tools for the folding / bending of the tube after V-Notching

    Is there any deformation to the tube?
    Yes, our V-Notch is an unsupported cut, meaning there is no mandrel or ID support to the tube. This means that the V-Notch tool can be used anywhere down the length of a tube, unlike a supported cut that is location-specific.

    Because the tube ID is not supported, the top wall of the tube will deform inward. The front and rear vertical walls are clamped, to prevent any deformation, and the bottom wall is supported by a die, also preventing deformation.

    How much deformation can I expect?
    The amount of deformation you will experience is affected by many factors, including tooling sharpness, press speed, wall thickness, weld seam location, amount and type of cutting oil used. For this reason, it is not possible for us to estimate how much your tube will deform.

    Can you send samples of a V-Notched tube for us to evaluate?
    Because the amount of deformation, as descrbed above, will vary, we do not provide samples. We do not want to create an expectation of how much deformation will be produced, as you may experience more or less than any samples we provide. Because deformation is confined to just one wall, some of our customers fill the depression with weld, which can be ground and polished for applications where appearance is critical.

    Can I notch different tube sizes?
    Yes, up to the maximum capacity listed, but some components must be changed or adjusted.

    • To change tube size, Front Spacers are changed
    • To change gauge, front spacers are shimmed and rear cams are changed