800.272.8946Call
function googleTranslateElementInit() { new google.translate.TranslateElement({pageLanguage: 'en', layout: google.translate.TranslateElement.InlineLayout.SIMPLE}, 'google_translate_element'); }
Need help fabricating parts?
Contact Manor Tool
Tools For Tubular Part Fabrication
  • Cut Off Die

    TUBE CUT OFF - Dimple-Free, Minimal Burr
    Depend on Vogel for cut off equipment that will help you increase efficiency, while reduce part handling and cost! Our two-blade cutoff technique, originally patented in 1941, cuts tubes, up to 6” OD, with no OD deformation and minimal burr (10% or less of tube’s wall thickness). Best results achieved with mild steel tubing aluminum, half hard or full hard brass & copper.

    • No OD Deformation
    • Minimal Burr
    • Up to 6” OD capacity
    • No chips to remove from part
    • Minimal scrap loss per cut
    • Fast production rates
    • Low maintenance costs
    • Low perishable costs
    • Quick change over
    CUT OFF DIES
    Each cut off die will handle a wide range of tube sizes, up to the maximum capacity shown. To change the size of tube to be cut, simply change the die inserts that clamp the tube. The insert changeover may be performed with the cut off die in the press, to reduce down time. Die Inserts are sharpenable.  Vertical Blades are low-cost, easily sharpenable and replaceable. Our Horizontal Blade design is reversible for a fresh edge without resharpening.

    NOTE: Die inserts and blades sold separately.

    Watch cut off die video
    Ver video en Español

  • cut_off_die02

    TUBE CUT OFF - Dimple-Free, Minimal Burr
    Depend on Vogel for cut off equipment that will help you increase efficiency, while reduce part handling and cost!  Our LHP Series Cut Off Dies are designed for deformation-free cutting of square and rectangular tubing. These dies may be upgraded, at a later date,  for cutting round tubing.

    • No Deformation
    • Minimal Burr
    • Up to 3-7/16" square capacity
    • No chips to remove from part
    • Minimal scrap loss per cut
    • Fast production rates
    • Low maintenance costs
    • Low perishable costs
    • Quick change over
    CUT OFF DIES
    Each cut off die will handle a wide range of tube sizes, up to the maximum capacity shown. To change the size of tube to be cut, simply change the die inserts that clamp the tube. The insert changeover may be performed with the cut off die in the press, to reduce down time. Die Inserts are sharpenable.  Vertical Blades are low-cost and easily sharpenable.

    NOTE: Die inserts and blades sold separately.

  • LHC

    TUBE CUT OFF - Dimple-Free, Minimal Burr
    Depend on Vogel for cut off equipment that will help you increase efficiency, while reduce part handling and cost! Our LHC Cut Off Die is designed for up to 1-1/8" square tubes and custs with no deformation and minimal burr (10% or less of tube’s wall thickness).

    • No Deformation
    • Minimal Burr
    • No chips to remove from part
    • Minimal scrap loss per cut
    • Fast production rates
    • Low maintenance costs
    • Low perishable costs
    • Quick change over

    CUT OFF DIES
    Each cut off die will handle a wide range of tube sizes, up to the maximum capacity shown. To change the size of tube to be cut, simply change the die inserts that clamp the tube. The insert changeover may be performed with the cut off die in the press, to reduce down time. Die Inserts are sharpenable.  Vertical Blades are low-cost & easily sharpenable.

    NOTE: Die inserts and blades sold separately.

Close